Memoria Kingston Hyper Beast Hx321c11t3k4/16 (16gb 2x8gb)

Descripción

In perfect condition. KHX21C11T3K4/16X kit, same as HX321C11T3K4/16 16GB (8GB 1G x 64-Bit x 2 pcs.) DDR3-2133 CL11 240-Pin DIMM Kit.

DESCRIPTION
HyperX HX321C11T3K4/16 is a kit of four 1G x 64-bit (8GB) DDR3-2133 CL11 SDRAM (Synchronous DRAM), 2Rx8 memory modules, based on sixteen 512M x 8-bit FBGA components per module. Each module kit supports Intel® XMP (Extreme Memory Profiles). Total kit capacity is 16GB. Each module kit has been tested to run at DDR3-2133 at a low latency timing of 11-12-12 at 1.6V. The SPDs are programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. Each 240-pin DIMM uses gold contact fingers. The JEDEC standard electrical and mechanical specifications are as follows:

SPECIFICATIONS
11 cycles)DDI(LC Row Cycle Time (tRCmin) 48.125ns (min.) Refresh to Active/Refresh 260ns (min.) Command Time (tRFCmin) Row Active Time (tRASmin) 35ns (min.) Maximum Operating Power TBD W* (per module) 0 - V 49gnitaR LU Operating Temperature 0o C to 85o C Storage Temperature -55o C to +100o C *Power will vary depending on the SDRAM used.

FEATURES

• JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply • VDDQ = 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
• Bi-directional Differential Data Strobe • Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset • Height 1.827” (46.41mm) w/ heatsink, double sided component

XMP TIMING PARAMETERS
• JEDEC: DDR3-1600 CL11-11-11 @1.5V
• XMP Profile #1: DDR3-2133 CL11-12-12 @1.6V
• XMP Profile #2: DDR3-1600 CL9-9-9 @1.5V